Plastics9 min read
Wall thickness rules for moulded parts
How nominal wall, transitions and rib geometry decide fill pressure, sink marks and cycle time, with practical ranges by material and the checks to run before tooling.
Read
Sourcing notes for custom parts
Drawings, tooling, quality and landed cost, from the team that runs the programmes.
All guides, page 16
Browse the full library.
Machining9 min read
Aluminium die casting alloys: ADC10, ADC12 and A380
Three common die casting grades, compared by fluidity, strength, machining and finish, with the questions that stop a substitution from becoming a surprise.
Read
Machining10 min read
Die casting porosity: reading the defect, choosing the test and setting acceptance
Gas, shrinkage and cold shuts look different, form in different places and need different fixes. A practical guide to identifying porosity and agreeing what is acceptable.
Read
Machining10 min read
Heat sinks for EV chargers and inverters
Dust, rain and a sealed enclosure change the cooling problem. The heat sink has to work with the IP rating, not against it.
Read
Machining10 min read
Machining tolerances: what to specify and what to avoid
A general tolerance covers most of a machined part. The rest should be a short list of calls that come from the function, not from habit.
Read
Machining9 min read
Thermal interface materials: pads, paste and graphite
How to choose a thermal interface by gap, heat flux and assembly method, and why the thinnest material is not always the best one.
Read
Machining11 min read
CNC machining design guide for electrical parts
Practical rules for copper, brass and aluminium parts, from corner radii and wall thickness to burrs that damage insulation.
Read
Machining9 min read
Die casting wall thickness and draft: the two limits that shape the part
How wall thickness controls fill and shrinkage, how draft controls ejection, and the drawing checks that catch both before the die is cut.
Read
Machining9 min read
Heat sink machining and interface flatness: milling, skiving and control
How a heat sink face is cut, measured and held flat, and why a flatness callout without a datum or a method is not a specification.
Read
Machining11 min read
Heat sinks for power electronics and IGBTs
A module has a thermal stack, a mounting pressure and a cycling life. The sink is one layer, and the interface between them decides how long the stack lasts.
Read
Machining9 min read
Machined parts for sensors and instrumentation: tolerance, finish and stability
Sensor housings and instrument bodies fail on the features that look small: a sealing face, a bore fit, a thread or a surface that moves after machining.
Read
India9 min read
Sourcing agent vs direct factory: which model fits your programme?
Control, cost, accountability and hidden fees compared, and the hybrid model that often works better than either extreme.
Read
Go from reading to checking
The guides are built around the same questions as the free tools. Size a busbar, check an ISO 2768 callout, build a first article report or compare landed cost.
The Qumek dispatch
One useful email a month
Drawing notes, supplier checks, tariff changes and the questions buyers keep asking. No newsletter filler, no daily drip.