Lugs8 min read
Terminal plating: tin, nickel and silver
The finish has to protect the surface, hold contact resistance and survive the crimp. A comparison of the three common coatings and the callouts that make them inspectable.
Read
Topic hub
Lugs and terminals
Most termination failures start before the crimp tool is picked. These guides cover lug and terminal selection, bimetallic joints, crimp quality, plating and the tests that prove a joint will hold.
Guides in this topic, page 3
Lugs9 min read
Wire crimp quality: strand damage and bellmouth
A crimp cross-section shows what a pull test cannot: voids, cut strands and a bellmouth that was closed flat. How to prepare, read and accept one.
Read
Lugs9 min read
Bimetallic lugs: aluminium cable to copper busbar
Joining aluminium to copper is a corrosion problem before it is a connector problem. How a bimetallic lug is built, selected and proved.
Read
Lugs9 min read
Braid flexibility and bend life
Flexibility is not the same as fatigue life. A braid that bends easily can still fail early if the radius, the stroke or the termination concentrates strain in a few strands.
Read
Lugs8 min read
Insulated vs uninsulated terminals: voltage, environment and assembly cost
The sleeve is not decoration. It changes touch protection, strain relief, inspection and the cost of a mistake, and it is not always the safer choice.
Read
Lugs9 min read
Lug and terminal cost drivers
Where the money goes in a lug quote: metal, plating, forming, tooling and volume, and which lines a buyer can actually move.
Read
Lugs9 min read
Terminal spring force and contact resistance
Normal force, true contact area and joint temperature are one chain. How to read it, measure it and keep a terminal joint stable.
Read
Lugs9 min read
Braid termination: welded, crimped and bolted
A braid is only as good as the point where it stops being flexible. Compare the three termination routes on resistance, strength and the inspection each one needs.
Read
Lugs9 min read
Custom connector assemblies: overmoulding and strain relief
How an overmoulded cable assembly is designed and built, from the termination inside the mould to the bend test that proves the boot.
Read
Lugs8 min read
DIN 46235 lugs: dimensions and drawing callouts
A dimensional standard tells a supplier what shape to make. It does not tell a buyer whether the crimp will hold. How to read the callouts and what to add.
Read
Lugs8 min read
One-hole vs two-hole lugs: vibration and rotation
A second bolt costs money and space. It also stops a lug rotating on a vibrating terminal. Here is when that trade is worth making.
Read
Lugs9 min read
Ring terminals, fork terminals, pin terminals and flag terminals
Four terminal families, four different connections. How the shape of the terminal decides access, retention and the risk of a loose joint.
Read
The Qumek dispatch
One useful email a month
Drawing notes, supplier checks, tariff changes and the questions buyers keep asking. No newsletter filler, no daily drip.